See what our Experts say about this Blue Ox Flat Tow Wiring Harness

• Fuse Bypasses Needed To Flat Tow A 2015 Buick Enclave
  Hey Steven, To bypass the 15 amp ECM and Onstar fuses you can use the # RM76514 and for the 50 amp BATT1 fuse you can use the # RM-76517. These both come with switches to activate/deactivate the fuses. You'll likely need to splice in some extra wires to run them up to the dash for easier access.
  view full answer...
• What Fuse Does the Blue Ox Fuse Bypass Replace On a 1997 Jeep Wrangler
  Hey Matt, I checked around a bit and it looks like to install the Blue Ox Fuse Bypass Switch # BX88272 on your '97 Jeep Wrangler you need to remove the tow fuse - which is highlighted in the attached picture and replace it with # BX88272. This fuse should be the number 20 fuse, which is a 15A fuse, on the interior by the passenger side. Let me know in the comments if you have any other questions, and Id be happy to help!
  view full answer...
• Parts Needed to Flat Tow a 2015 GMC Terrain
  In order to convert the 4-way trailer connector on your 2014 Thor ACE 29.2 to a 6-way trailer connector you would want to use the Mighty Cord Trailer Connector Adapter part # A10-6034VP. The adapter plugs into the 4-way you have on your RV and will require you to hardwire in 3 additional wires. The white wire is for the ground and will need to be attached to a clean bare metal surface. The black wire will then need to be ran to the battery with an in-line fuse holder such as part # SWC9539...
  view full answer...
• Recommended Fuse Bypass For Flat Towing A 2013 Honda CR-V
  If your owner's manual says to only pull the #19 ACC radio fuse, you can use the Blue Ox Fuse ByPass Switch for Towed Vehicles # BX88272. If it states to pull the #19 ACC radio fuse and the #20 ACC key lock fuse you'll need to use the Roadmaster FuseMaster Fuse Bypass Switch for Towed Vehicle # RM76512. The Blue Ox Fuse ByPass Switch for Towed Vehicles # BX88294 you referenced is for ATC or ATO fuses. The fuses you'll be pulling are Mini, and ATC fuses are much larger.
  view full answer...
• Does Brake Buddy Select Supplemental Braking System Drain Vehicle Battery
  The Brake Buddy Select 3 part # HM39524 like you have plugs into a power outlet in the tow vehicle to power the brake setup. So what that means is that it's draining your vehicle battery as it's being used. Using a fuse bypass won't prevent this from happening. Only solution is a battery charge kit like the part # RM-156-25 like it sounds like you tried which will keep the battery topped off so that when it's being used it will hopefully recharge.
  view full answer...
• Fuse Bypass Kit to Bypass 50-Amp and 15-Amp Mini Fuses in 2011 Buick Enclave
  For your 50-amp fuse you can use Blue Ox ByPass Switch # BX88274 and for your 15-amp mini fuse Blue Ox # BX88272. The Roadmaster FuseMaster Fuse Bypass Switch # RM76514 that you referenced does provide 2-fuse bypass capability but its amperage rating for both is 20-amps.
  view full answer...
• Which Fuse Needs to be Pulled to Flat Tow 2013 Honda CR-V
  According to the online owner's manual for your 2013 Honda CR-V, for extended towing, you will remove the 7.5 A accessory radio fuse to prevent the battery from running down. This should be located in the interior fuse box. For a fuse bypass switch to use so you do not need to remove the fuse each time you tow your vehicle, I recommend looking at the Blue Ox Fuse ByPass Switch # BX88272. You will just relocate the specified fuse with this bypass and flip the integrated switch. To drive...
  view full answer...
• Parts Needed to Flat Tow a 2013 Buick Enclave Front Wheel Drive
  To flat tow your 2013 Buick Enclave you're going to need a tow bar, base plates, wiring for the lights, a supplemental braking system for the brakes, and possibly a high-low adapter. I suggest the Blue Ox # BX1708 for a base plate kit. To connect to the RV I like the Avail # BX7420 for a tow bar because of the 10,000 pound weight capacity. The Avail also includes safety cables. To power the lights of the Enclave use the diode kit # RM-154. According to an online owner's manual for a...
  view full answer...
• How To Cut Power To A Jensen Mechless RV Stereo That Won't Turn Off
  First, I recommend removing your Jensen Mechless RV Stereo # JWM10A from the wall and removing the fuse from the back of the unit to fully reset it. If this doesn't fix the issues you're having with the unit not powering down when you press the power button then you can install a fuse bypass switch like the # BX88272 to cut the power with the flip of a switch.
  view full answer...
  
• How To Disable the Auto Level Suspension While Towing With a 2011 GMC Yukon XL Denali
  The easiest way to disable the Continuous Damping Control Suspension (CDC) on your 2011 GMC Yukon XL Denali is to pull the " Electronic Stability Suspension Control, Automatic Level Control Exhaust" fuse which is located in the #2 position on the under hood fuse box. If you don't want to open the hood and do this each time you tow, you can install the Blue Ox Fuse ByPass Switch part # BX88272.
  view full answer...
  
• Fuse Bypass for Flat Towing 2011 Honda Fit
  What you need is a fuse bypass. If your fuse is 20 amps or less you can use the Blue Ox Fuse ByPass Switch # BX88272. However, based on what other Honda Fit owners have reported it sounds like you have a 30 amp fuse. If that is the case, you will need the Blue Ox Fuse ByPass Switch - High-Amp Fuse # BX88274 which can handle up to 50 amps.
  view full answer...
• Does Rear Wiper Fuse Need to be Pulled to Flat Tow a 2019 Chevy Equinox
  According to the owner's manual for your 2019 Chevy Equinox there will be a power draw while you're flat towing so it calls for charging the battery during travel. This can be accomplished by using a wiring kit like the Roadmaster # RM26FR and then adding the Charge Line Kit # RM-156-25 so power from your motorhome will charge the battery. It's entirely possible that removing the fuse for the rear wiper will keep the battery from being drained but that's not something we've looked into...
  view full answer...
• What Fuses on a 2013 Buick Enclave Need to be Pulled Before it Can be Flat Towed
  I checked the owners manual for a 2013 Buick Enclave and you will need to remove the 15 amp OnStar and ECM fuse. These are in the battery compartment behind the passenger seat on the floor. You will also need to remove the 50 amp BATT1 fuse from the underhood fuse block. For your 50-amp fuse you can use Blue Ox ByPass Switch # BX88274 and for your 15-amp mini fuse Blue Ox # BX88272. What this will do is allow you to deactivate these circuits with just a switch instead of having to...
  view full answer...
• What Does the Blue Ox Fuse ByPass Switch for Towed Vehicles Shut Off On a 2014 Honda CR-V
  The Blue Ox Fuse ByPass Switch for Towed Vehicles part # BX88272 which is a fit for a 2014 Honda CR-V will need to be installed on the #19 ACC fuse slot. If done correctly, it will kill power to both the radio and navigation screens. The owner's manual actually identity's the wrong fuse for this so please disregard that. I have attached a photo below to clarify.
  view full answer...
  
• Fuss Bypass Switch For Windshield Wiper Circuit
  We have a bypass fuse switch, the Blue Ox Fuse ByPass, # BX88272 it is designed for a different purpose but meets the description of what you are asking for.
  view full answer...
• Recommended Fuse Bypass Kit for 2010 Honda CR-V
  Yes, I did some checking and the Blue Ox Fuse Bypass part # BX88272 that you referenced is a confirmed fit for your 2010 Honda CR-V.
  view full answer...
• Does Fuse Need to be Removed When Not Towing a 2018 Jeep Cherokee
  I do have a solution for you but since we don't carry or install Mopar parts I wouldn't be able to tell you if the service tech you spoke with knew what they were talking about or not. Typically a fuse is pulled to keep the battery from draining. I am not sure why a fuse would need to be removed when your 2018 Jeep Cherokee is not being towed though. If your fuse does need to be removed each time you are done towing your Jeep then I recommend installing a few bypass switch like the Blue...
  view full answer...
• Recommended Fuse Bypass Switch for a 2009 Honda Fit
  You are correct in that the Roadmaster FuseMaster Fuse Bypass part # RM76511 and the Blue Ox Fuse ByPass Switch part # BX88272 both have a 20 amp max fuse rating. This is mainly due to the gauge of wire that is used in the harness in relation to the distance that the circuit needs to travel. However, I do still have a solution for you that will not require you to physically pull the fuse each and every time and that is the Blue Ox Fuse ByPass High-Amp Fuse Switch part # BX88274 which...
  view full answer...
• Fuse Bypass Recommendation for Flat Towing a 2015 Chevy Sonic
  The recommended fuse bypass for your 2015 Chevy Sonic is the part # RM76511. We confirmed this with our contacts at Roadmaster. I attached an install video for this bypass on a very similar 2016 Chevy Sonic as yours as well.
  view full answer...
• Is Blue Ox # BX88272 the Correct Fuse ByPass Switch for my 2000 Chevrolet S-10 Blazer
  Yes, the Blue Ox, # BX88272, is the correct fuse bypass switch for your 2000 Chevrolet Blazer which requires the RDO BATT (Radio/Battery) fuse to be pulled during flat towing.
  view full answer...
• Can Blue Ox Fuse ByPass BX88272 be Used on a 2014 Honda CR-V
  Yes, your 2014 Honda CR-V can use the Blue Ox Fuse ByPass part # BX88272. For your CR-V normally the # 19 fuse needs to get pulled which is what the # BX88272 will allow you to do. However, in some cases the owners manual will state that you need to deactivate the # 20 fuse too which means that instead you could use the part # BX88273 which allows you to kill two circuits with one switch.
  view full answer...
• Fuse Bypass Switch Recommendation For 2008 Pontiac G8
  The fuse bypass switch that would be a fit for your 2008 Pontiac G5 is the Roadmaster FuseMaster, part # RM76511. This will allow you to flat-tow your vehicle without draining the battery. This does not have to be removed when you want to do normal driving. I have attached a link to a fuse bypass being installed. The vehicle is different than yours, but the installation would be similar and will give you an idea how this is installed. In case you do not have all of the components needed...
  view full answer...
• Parts Needed and Procedure for Flat Towing a 2015 GMC Terrain
  According to the online manual for the GMC terrain that I reviewed the vehicle can be flat-towed once a few preparation steps are taken, including removal of fuse 32 to prevent battery drain. I suggest you refer to your owners manual, specifically the section identified in the index as Recreational Towing, just to confirm that your particular Terrain is suitable for flat-towing and to become familiar with the steps necessary. Here is what I found in the manual: 1. Position the vehicle...
  view full answer...
• Recommended Fuse Bypass Kit for a 2023 Toyota RAV4 Using ATM-LP Low Profile Fuses
  For your 2023 Toyota RAV4, you can use the Blue Ox Fuse ByPass Switch for Towed Vehicles - ATM Mini-Fuse # BX88272. This is a universal kit that works with your ATM-LP low profile fuse and will bypass your toads fuse so your battery does not drain while being towed. Also, this part is not meant to be installed on a fuse that has more than a 20-amp rating.
  view full answer...

Do you have a question about this Flat Tow Wiring Harnes?